Meta Biner Lc

Meta Biner Lc

Biner LC is an innovative light-cure, fluoride-releasing, and radiopaque cavity liner and base material, specifically designed for compatibility with adhesives, composites, and conventional restorative materials.

Containing hydroxy calcium phosphate in a urethane dimethacrylate resin, Biner LC establishes chemical bonds with adhesive primers, composites, and other resin-based materials. Additionally, it forms micromechanical bonds with dentin for enhanced adhesion.

INDICATIONS :  

• Protect pulp of the tooth  
• Lining under all filling materials  
• Protection when applying the total etch technique  

CONTRAINDICATIONS :  

Biner LC should not be used if patients are known to be allergic to methacrylate resins  

INSTRUCTIONS :  

• ① Isolate prepared teeth and air dry gently  
• ② Place a disposable tip securely onto Biner LC syringe  
• ③ Apply Biner LC to the dentin in increments. Remove Biner LC from enamel margin and light cure for 40 seconds, depending on the light curing unit.  
• ④ Apply bonding system to enamel. Light cure, Continue with layer of composite until cavity is filled.  

SIDE EFFECTS :  

None known to date  

STORAGE :  

• Store at room temperature  
• Close syringe cap immediately after use.  
• Avoid from directly sun light.  

SHELF LIFE :  

3 years  

COMPONENTS :  

Biner LC 2g×2 syringes   

Features :  

• Excellent biocompatibility with dentin and pulp
• Chemically bonds to adhesives and composites
• Insoluable in water and oral fluids
• Flow-on-demand handling and easy dispensing

Composition:-

• Calcium hydroxy phosphate, UDMA, photoinitiator
• Barium aluminum silicate

Storage:-

• Store at room temperature  
• Close the syringe cap immediately after use.  
• Avoid direct sunlight.  

Packaging :  

• 2 x 2 syringe (2gm )

Direction To Use :

• Prepare the tooth: Ensure the tooth surface is clean, dry, and free from debris or contaminants.
• Apply adhesive primer: Apply a suitable adhesive primer to the prepared tooth surface according to the manufacturer's instructions. Allow it to react for the recommended time.
• Dispense Meta Biner LC: Dispense an appropriate amount of Meta Biner LC using a syringe or other dispensing method onto a mixing pad or dish.
• Mix thoroughly: Using a suitable spatula, mix the Meta Biner LC paste thoroughly for the recommended time to ensure proper homogeneity.
• Apply to cavity or base: Using a suitable instrument, apply the mixed Meta Biner LC directly into the prepared cavity or as a base material. Ensure complete coverage and adaptation to the tooth structure.
• Light cure: Expose the applied Meta Biner LC to a suitable light curing unit according to the manufacturer's instructions. Ensure proper light intensity, exposure time, and distance to achieve adequate polymerization. Pay attention to any specific curing recommendations for the product.
• Check for complete curing: Verify that the Meta Biner LC has fully cured by inspecting its hardness and stability. Use a suitable instrument to gently test the surface for any soft or uncured areas.
• Proceed with restorative material: Once the Meta Biner LC has adequately cured, continue with the placement of adhesives, composites, or other resin-based restorative materials as desired.