Waldent Alchem Nanoflow Zirconium Flowable stands out as a superior flowable composite, offering exceptional strength and wear resistance. With optimal surface affinity, it effortlessly reaches challenging areas, ensuring both esthetics and easy-to-use flow-on-demand handling.
Indications:
Waldent Alchem Nanoflow Zirconium Flowable
- Indicated for direct filling of class V (Cervical Caries)
- Root erosions
- Wedge-shaped defects
- Fillings of anterior teeth (Class III & IV)
- Small fillings in posterior teeth
- Block out of undercuts
Features
- It has high radiopacity and mechanical strength
- Superior wear resistance
- High filler load
- Flowable consistency
- Low shrinkage
- Excellent colour stability
- Excellent flexural strength.
Composition:
- Bisphenol A Glycidyl methacrylate (Bis-GMA)
- Urethane Dimethacrylate (UDMA)
- Bisphenol A diglycidyl methacrylate ethoxylated (Bis-EMA)
Storage:
- Store in a cool and dry place
- Store at room temperature of 5-30 degrees C
- Store away from direct sunlight
Packaging
Driection to Use
- Isolation: A rubber dam is the preferred method of isolation.
- Cavity preparation: Prepare cavity with minimal tooth reduction.
- Apply Etchant Gel to enamel and dentin surfaces for 15 seconds. Rinse thoroughly for 15 seconds with water.
- Dry with clean, oil-free, air without desiccating the dentin.
- Do not allow the etched surface to become contaminated with saliva or blood during the bonding procedure.
- Adhesive: Immediately after blotting, apply 2-3 consecutive coats of adhesive to etched enamel and dentin for 15 seconds with gentle agitation using a fully saturated applicator. Remove excess solvent by gently drying with dry air for at least 5 sec to ensure a uniform glossy surface. Light cure for 20-30 seconds.
- Apply the material with the applicator tip directly in the cavity and pre-contour with a suitable instrument.
- The layer should not be thicker than 2mm.
- Light cure for 40 sec using a standard curing light.
