Waldent NanoFlow Bulk, a nano-hybrid technology-based bulk fill flowable composite, is engineered for excellent strength, durability, and wear resistance. Its remarkable surface affinity ensures easy penetration into challenging areas. Moreover, it enables application in bulk layers of up to 3-4mm, reducing the need for multiple increments during placement—a superior option in dental composites.
Indications
- Direct filling of Class V (cervical caries), root erosions, wedge-shaped defects.
- As a primary bulk filling material for posterior teeth.
- Fillings of anterior teeth (Class III & IV).
- Block out of undercuts.
- Repairing composite and ceramic veneers and bis-acryl provisional temporaries
Contraindication
- Do not use NanoBulk on patients with known sensitivity to methacrylates or any other element present within NanoBulk.
- Do not use if working area is not dry or the recommended application technique is not possible, or if the pulp is exposed.
Features
- High wettability for optimum adhesion.
- Low polymerization shrinkage.
- Higher filler load of 70% w/w.
- Excellent physical & mechanical properties.
- Low surface roughness & high gloss polishability
Composition
- Silanated Barium Glass Powder (70% Inorganic Filler)
- Amorphous Fumed Silica
- Bisphenol A Glycidyl Methacrylate, Ethoxylated Bisphenol A Dimethacrylate, Urethane
- Dimethacrylate, Triethylene Glycol Dimethacrylate.
Storage
- Store in a cool and dry place
- Store at room temperature of 5-30°C
- Do not freeze
- Store away from direct sunlight
Packaging
Driection to Use
- Use a rubber dam for isolation.
- Prepare the cavity with minimal tooth reduction
- Apply Waldent BestEtch or any 37% phosphoric acid-containing etchant to enamel and dentin surfaces for 15-30 seconds, according to the surface to be etched.
- Rinse thoroughly for 15 seconds with water.
- Dry with clean, oil-free air without desiccating the dentin
- Do not allow the etched surface to become contaminated with saliva or blood during the bonding procedure.
- Immediately after blotting, apply 2-3 consecutive coats of Waldent NanoBond Nano-Hybrid Dental Flowable Restorative Material NanoFlow Bulk Universal Adhesive or any other adhesive to etched enamel and dentin for 15 seconds with gentle agitation using an applicator.
- Remove excess solvent by gently drying with dry air for at least 5 seconds to ensure a uniform glossy surface
- Light cure for 20-30 seconds
- Apply the NanoBulk with the applicator tip directly in the cavity. The layer should not be thicker than 3-4mm.
- Light cure for 40 seconds using a standard curing light, such as the Waldent Eco Plus Light Curing Unit.
